The Putco Stainless Steel Fender Trim for Chevy Silverado part # P97289 is 1-1/2" wide. Therefore, if you measure 1-1/2" up from the lip of the wheel well that will give you an approximate location of the fender trim coverage. view full answer...
I checked with Curt, for your 2018 Volkswagen Tiguan SEL R-Line you are going to want the Curt Trailer Hitch Receiver item # C13381. This hitch is custom fit and bolts to your Tiguan with included hardware.
VW added some extra trim pieces for the R-Line model. Those will need to be trimmed down significantly for the hitch to be installed. Removing or modifying these trim pieces will not affect the function of your hitch and shouldn't affect the appearance of your VW as the pieces are... view full answer...
I have a solution for you but none of the hitches we offer for your 2019 Acura RDX with Tech Package can be used with a 19 inch spare stored underneath the vehicle. So what your best option would be is replace the spare you have with a smaller one from Acura so that you can then install the Draw Tite hitch part # 76268.
For trailer wiring you'd then want the Tekonsha kit part # 118800 and you'd be set with an easy to install trailer wiring harness setup that's also very reliable. view full answer...
The max towing capacity of your Jeep Grand Cherokee 3.6L will depend on the trim level. For example, the Limited and Laredo have a towing capacity of 3,500 lbs.
Other trim levels for the 3.6L vary depending on whether you have the 2WD or 4WD/AWD model. In this case, the 2WD remains at 3,500 lbs and the 4WD goes up to 6,200 lbs. You will want to consult your owner's manual to find the exact towing capacity of your vehicle.
A hitch like the # C13182 Curt Receiver Hitch has a maximum gross... view full answer...
You will need to consult your owner's manual for confirmation on the towing capacity of your 2019 Toyota RAV4 but the trim package on your vehicle and the engine/transmission will determine the capacity. From what I was able to find with my resources, the RAV4 has a capacity of 1500-lbs for some trims and up to 3500-lbs for others. The Draw-Tite # DT82QR you were looking at is a good choice, but it will not increase the towing capacity of your vehicle even though it has a 675-lb tongue... view full answer...
For your 2022 Toyota Highlander without tow package we have the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # TK99FR. This is confirmed to fit your 2022 Toyota Highlander without a tow package. This custom-fit T-One connector plugs into your vehicle's wiring harness, which is located behind the trim panel near the driver's side rear seat belt bracket. You will have to pull back the side trim panel to access this harness.
Once installation is complete, the 4-way flat... view full answer...
The etrailer hitch, part # e98843, for your 2018 Kia Sorento is rated for 750 pounds of tongue weight and 5,000 pounds of trailer weight. In most cases the hitches are rated for more than the actual vehicle. To determine your vehicle's capacities you need to check your owners manual for what the vehicle is rated for. From the online copy I found, the towing capacity for the 2018 Kia Sorento is rated between 2,000 and 5,000 pounds of gross trailer weight. This number is determined by the... view full answer...
To install the Draw-Tite item # 76194 hitch on a 2024 Volvo XC60 you'll need to cut out a 2-1/2" x 3-1/2" rectangular section off your Volvo's fascia that faces the ground. It's just a thin piece of plastic that extends past your bumper underneath the SUV. Trimming this piece allows the 2" receiver and the safety chain loops to extend below the vehicle and bumper. The only way you will ever see the hole that needs to be cut out is if you lie underneath your Volvo and look up.
The Draw-Tite... view full answer...
Hopkins Semi-Custom Auto Floor Mats # HM79100 are listed for your 2016 Chevy Colorado. The front mats 27-1/2 inches long front to back and 20 inches wide and the rear mat is 21-1/2 inches front to back and 35 inches wide.
As a semi-custom fit the mats can be trimmed for a better fit. This is not the same a true custom fit option which is a direct fit, no trimming, and matches the contours of the vehicle floors they are designed for. I have linked the true custom fit mats for the 2016 Colorado... view full answer...
I sent your questions to Aries and they responded by telling me that the 3” step bars of the # AA204032-2 from the picture sits flush with bottom of door being this is a rocker panel mount, and the ideal weight limit is 250 lbs. the width of the bars is 3” this won’t protrude past the mirrors. Pre-molded mud flaps could be an issue with installation due to the slight bend of step bar. The brackets are made out of carbon steel . this will be considered a light duty application due to the... view full answer...
From what I could find, it does look like all trim levels on the 2019 Honda CR-V are limited to 1,500 pounds towing. This can be verified by checking the driver side door jamb. There is a sticker with all capacities the vehicle is rated to. The Draw-Tite # 76128 is technically rated up to 4,500 pounds, but you are limited to the highest capacity of the lowest rated component, which in this case will be the vehicle. view full answer...
When we installed the Stealth Hitches Hidden Trailer Hitch Receiver w/ Towing Kit # SH25VR on a 2019 BMW X5 in our shop we found it to have approximately 11-1/2" of ground clearance with the receiver tube installed. This can vary from vehicle to vehicle depending on tire sizes and trim level. And when you remove the receiver tube it will not affect your ground clearance.
I recommend getting the Carrying Case # 391CASEC to hold the ball mount and receiver connections. This will ensure... view full answer...
The Hidden Hitch by Draw-Tite item # DT36GR is only listed as fitting the standard model of the 2010 BMW X5 because of the rear fascia and trim added to the rear of the M models. You would have to make significant cuts in your rear bumper area to get the receiver to attach to the rest of the hitch.
The only hitch that is confirmed to fit the 2010 BMX X5M is the Stealth Hitches Hidden Rack Receiver item # SH29VR. view full answer...
The highest rated trailer hitch that we carry for the 2011 Hyundai Santa Fe, is the Draw-Tite Trailer Hitch, # 75684, which has a 3,500 lb weight carrying rating and 350 lb tongue weight rating. With weight distribution this hitch is capable of 5,000 lbs and 500 lbs respectively.
This means that as long as your specific vehicle is rated to tow at least the same amount of weight, you will be limited to the rating of the trailer hitch. If your vehicle is rated to tow less, you will be limited... view full answer...
The only difference in the Curt item # C13176 and the etrailer item # e98909 is the finish and the cost. Both hitches are manufactured by Curt to the same standards and specifications. I prefer the etrailer hitch item # e98909 because of its flat matte finish. It tends to blend in better beneath a vehicle's trim then the glossy finish of the Curt item # C13176.
Both of these hitches are confirmed to fit the 2022 Chevy Colorado. I have linked a couple of installation videos below so you... view full answer...
From what I was able to determine from my research, the 2014 GMC Yukon XL has a towing capacity of 7800 to 7900-lbs depending on the trim package; you'll want to consult the owner's manual for the best information on this for your Denali trim. When it comes to weight distribution hitches, they're not going to increase the towing capacity of your vehicle- you'll always be limited to the lowest rated component in your towing setup which would be the vehicle in this case.
When it comes to... view full answer...
We have the two parts you'll need to add a 5-flat to your 2023 Chevy Express van but like the 7-way, they don't make just one that will add a 5-way to your vehicle.
The first connector you will need is the Curt Wiring Harness item # 55540. This custom fit connector plugs into existing wiring in your rear cargo area which is located behind the interior trim panels in your rear cargo area. This will provide you with a 4-flat connector.
The second part you'll need is the Curt Trailer Connector... view full answer...
Generally you are not able to increase your tongue weight rating on your 2018 Nissan Rogue, you can reach out to your local Nissan Dealer to verify this for your specific model. They are the only ones that can tell you what your specific weight capacity is on your specific trim level with your factory installed options.
While the Curt Trailer Hitch Receiver # C13204 is rated for 525lbs of tongue weight and the owners manual of your Rogue shows a maximum trailer towing tongue weight of... view full answer...
The best source for information on whether or not your 2016 BMW 328ix Gran Tourismo can tow this trailer is going to be the owner's manual; the Curt # C11367 has a capacity of 2000-lbs towing/ 200-lbs tongue weight, so it will handle a load that size but I am not able to find conclusive information on the vehicle's towing capacity with any of my sources. Additionally, removing or trimming the heat shield does not affect performance of the vehicle, so there's nothing to worry about in that... view full answer...
I spoke with Curt about the Curt Trailer Hitch Receiver part # C11524 for your 2017 Mini Clubman S and they informed me that the receiver tube sits right up underneath the bumper. The distance from the bottom of the bumper to the bottom of the receiver tube is 2". That said, I don't have any distances from the ground because this can vary by trim level and how much of a load is in the vehicle.
I have attached an install photo for you as well. view full answer...
Go To Results